#6634591, By FrancysPai Ultra/Super Street Fighter 4

  • FrancysPai 14 Oct 2010 12:24:58 56 posts
    Seen 4 years ago
    Registered 4 years ago
    Quint2020 wrote:
    I think I'm going to go the Datel route and follow this guide, it's probably overkill as I'm a fighting game noob really but a little project like this looks fun and hopefully I'll overcome my fear of soldering in the process!

    Now all I need to do is find somewhere to source the parts.....

    P.S. Sorry if I'm hijacking a seriously complicated looking SS4 discussion!

    I personally buy my parts from akihabarashop.jp , Though a lot of other people buy theirs from Gremlin solutions (they're a UK based site).

    Oddly enough, depending on what you're buying...it works out cheaper to buy from Akihabara.

    So long as your solders aren't touching and it's clean and shiny, you're good to go. I accidentally had a bit of solder crossing over the signal and ground points on my 360 pad before, oh god that was a nightmare to Desolder to stop the board shorting light kick everytime I plugged it in XD.

    nickthegun wrote:
    I hate playing vega. Properly hate, hate hate.

    Its my least favourite matchup by a long way.

    I could give you practice on that ;) Who do you main? I might be able to give you some tips.


Log in or register to reply